Alyssa K. Betts, Extension Field Crops Pathologist; akoehler@udel.edu and Adelaide Mullin
Fungicide use in sorghum is typically limited, but there can be a case for use in wet, humid conditions that favor foliar disease. A broad range of diseases including root rots, foliar lesions, stalk rots, and head molds can affect sorghum. In general disease pressure in sorghum remains low, but we can run into issues with sorghum Anthracnose caused by species of the fungus Colletotrichum. Symptoms include red to tan lesions on the leaves or stems (Figure 1), stalk rot, or grain infection. Fungal structures resembling pincushions (acervuli with setae) can be observed within the lesion under magnification (Figure 2). Anthracnose is favored by warm, wet conditions and susceptibility can vary across variety. In years with favorable weather or if a field is planted sorghum on sorghum, disease can move into panicles and grain (Figure 3). Serious yield loss can be observed in these cases. Resistant hybrids, seed treatments, and fungicides can be used to try to manage this disease. Previous research from Virginia Tech has shown that fungicides (priaxor or headline) were most effective at protecting yield in diseased fields when applied at flowering. Each percent increase of anthracnose disease severity can account for 0.5-1.25 bu/ac of lost yield potential (https://apsjournals.apsnet.org/doi/abs/10.1094/PDIS-10-18-1867-RE).
In recent seasons, additional products have been labeled for use in sorghum. In 2024 we began trial work comparing efficacy of Priaxor, Miravis Neo, and Adastrio at two application timings in two varieties. The tested timings included boot stage (Figure 4) and flowering (Figure 5), last year these timings were around 6 days apart. As you may recall, 2024 was a very dry season and as a result, almost no disease was observed. Results from this trial reinforced that in a year with no disease pressure there is no return on investment for applying a fungicide in sorghum. We are repeating the trial this season and in addition to a first-year field are also looking at fungicide response in a sorghum-on-sorghum planting. We will share results later this year once they are available. When considering fungicide application, scouting is important to determine the level of disease prior to flowering. Some studies have shown that the timing of disease onset is just as or more important than final severity, especially in wet, humid years. As a field approaches flowering, if disease is absent or low, a fungicide application is unlikely to be profitable for sorghum.
After grain fill, head molds become another concern. Head molds can cause pre- and post-harvest damage, reduce yield, and some of the fungi infecting the grain may form mycotoxins that can lead to quality issues. Chemical control of head mold fungi is typically not effective, insect control may be a better target since head molds are often associated with insect damage. Keeping mature grain from getting wet also helps to reduce head mold issues, but this can be a challenge depending on environmental conditions near the time of harvest. Hybrids are available that vary in susceptibility to anthracnose and head molds. Selecting moderately resistant lines over susceptible or very susceptible lines can help to reduce yield loss and mycotoxin contamination.
Figure 1. Leaf Lesions from Sorghum Anthracnose.
Figure 2. Sorghum Anthracnose lesion magnified to view fungal structures.
Figure 3. Sorghum head with almost no viable grain due to Sorghum Anthracnose.
Figure 4. Sorghum head at boot stage.
Figure 5. Sorghum head at flowering stage.